So I finally got a few consecutive days off to get my suspension done. This is what I found on both sides after removing the tires.
This was the drivers side, the passenger side had a similar break on the lower end and another crack forming at the top. But that's apparently what happens when you run the factory shocks till 120k with no sway bars and wheel them a little too hard.
But out with the old and in with the new.
For the front I went with Old man Emu HD coils and struts. Also I changed out the inner and outer tie-rods and boots and new cardone CV axles. I figured ill just get everything done in one shot and now I have some trail spares to carry.
For the rear I went with a set of bilstiens from PRG
For the couple miles I put on it so far with the new suspension I love the ride. A little stiff without a bumper yes but not that bad and they will soften over the next couple weeks.
Also while I was waiting for the last few parts for my front coilovers to show up. I got bored and during ECXC some inspiration from the 718 crew and decided to buy some LED roof rack lights.
Nothing special just some ebay lights. they work well. Its not a final finish this was just a mock up. I'm trying to find the best spot for light output and where its not an eye sore.