Any good reason that my little indicator light would stay on after I unlock the hubs and am in 2 wheel drive. It stays lit but dimmer than when I lock in.

Thanks
Clay

check the wiring harness for the 4X4 indicator light on the right hand side of the transfer case - see if the insulation has pulled away from the connector... a little bit of silicone or electrical tape should solve the problem.

If it is getting dimmer, but not going out, sounds like there is a short somewhere. Check where Jeff said first and then trace from there if that does not work.

thanksfor the help. I will be at worktomorrow so I will pull it inside where its warm and start the hunt